Recent content by retrotronic

FBA uses MAME romset. You just need to point it to your Mame folder. Make sure you are running correct romset. Mame4All uses Mame 0.37b5 so you also need a 0.37b5 romset to work. You can validate your romset using clrmamepro with 0.37b5 .DAT file to see if you have the right romset.

I think you can do this by adding: joystick_num=0 In .scummvmrc The other alternative is to try installing 'miceinjoy' from this page. The analog stick should then work as a mouse.... The program was wrote for the gcwzero but as the RG350 and GCWZero are basically the same devices it should...

You do this... Write a bash shell script as follows. Firstly, connect the RG350 to your computer and log in as root from Linux terminal. Windows users can use putty... This assumes Network in Gmenu2x is set to 'no password'. SSH [email protected] Press ENTER. Write the following script...

Everytime I start DOSBox on my RG350 it brings up the explorer window. What do I suppose to choose here? Also it creates no .DOSBox/.DOSBox.cfg on launch :( DOSBox version I have on my RG350 is dated 2019-11-12. Earlier version had the same problem (it just brings up the file explorer) I've...

Hi Dave Thanks for the response. Turned out the partition table on the card was the problem. I wiped it out with disk part, recreated a primary partition and reformmated to FAT32. All is good now.

I aquired my RG350. Upgraded to firmware 1.5 using Etcher on Linux Mint. Added localpack v3. All went well but... External SD card I formatted to Fat32 with default allocation size as per instructions, I even used FAT32 Format GUI to format the card, used default allocation size and quick...