No picture

[Margaret]

Hi, I am going into Xbmc and everything I load has the sound but no picture, please help anyone, am sure its something simple.

 

[David Savage]

Try going to system, then video, then acceleration and make sure decoding method is set to Hardware Accelerated then highlight all underneath see if this helps you.
Good luck

 

[Margaret]

Hi, I have gone into system,then video add on and there is nothing there it just says up one level ?

 

[Margaret]

Found it,done it, it was on hardware,only one wasn't highlighted so high lighted that, tried a film from earlier and it is working, but it was hit and miss so will keep an eye on it. Thanks for the advice.

 

[David Savage]

Hope it stays ok...and no worries glad I could help you.

 

[David Savage]

Hi, also in system>system>video output check Vertical blank sync is on Always enabled. Also further up look at
Use a fullscreen window than true fullscreen is highlighted to.
You can do one at a time and see if it helps you.
At the side there's a setting level you can change that to Expert, that should show more setting for you. Good luck
Dave